November 10, 2014

PROJECT SUB-OHM: THE “thinmaN” 150WATT BOX MOD – $125.99

Welcome The Big Uncle Of the “littlemaN”™! Project Sub-Ohm™ Has Created The “thinmaN”™ 150 Watts Mod!

Even since the introduction of the “littlemaN’™, “suitcase”™ and “fatbaby”™ Box mods, each creation has gain a huge popularity among the world of vapers! Now Project Sub-Ohm™ has found the perfect platform to build on its FOURTH box mod. The goal is simple, to create an affordable and even more powerful device that can satisfy the vapers out there!

Product Includes:

  • 1 “thinmaN”™ Mod by Project Sub-Ohm™
  • 1 USB Cord (For Upgrade Firmware Only! Not For Charging)


Product Descriptions:

The “thinmaN”™ series by Project Sub-Ohm™ is a powerful Variable Wattage Device that can adjustable it’s power from 7W to 150W in increments of 0.1 Watts! This device uses an upgraded YiHi SX330 Chip, which is capable of firing coils at 0.1 ohm up to 3.0 ohm. The “thinmaN”™ Mod is powered by dual IMR 18650 battery and is capable of producing up to 150 Watts of power! The two screws on the back of the device hold the battery cover firm and sturdy. The battery is removable. The OLED screen is bright and easy to read, and also shows you the wattage, resistance, output voltage and battery life. There are two ways of firing the device, a standard firing button and a revolutionary “Touch Firing”, which is located next the the 510 connection. This sensor allows the device to be fired using heat from your finger when press on to the plate.

Product Features:

  • Uses latest YiHi SX330 V3s Chip
  • Firmware is upgradeable via USB Port, up to 180 Watts
  • Full Aluminum Body For rigidity!
  • Capable of firing 0.1 ohm – 3.0 ohm build
  • Capable of putting out 150 Watts of power!
  • Reverse Polarity Protection
  • Output Short Protection
  • Low Resistance Protection
  • Battery Low Voltage Protection
  • Temperature Overheat Protection
  • Beautifully Engraved With Project Sub-Ohm™ Logo and “thinmaN”™ logo
  • Serialized for that personal touch
  • Matches all other Project Sub-Ohm™ products

Product Specs:

  • Output Power: 7W – 150W
  • Output Voltage: 1.0V – 7.0V
  • Input Current: 30A
  • Input Voltage: 6.2V – 8.5V
  • Loading Resistance: 0.1 ohm – 3.0 ohm
  • Low Resistance Protection
  • High Input Voltage Warning
  • Output Short Circuit Protection
  • Reverse Battery Protection

Product Recommendations:

  • FOR USE WITH 30 AMPS OR HIGHER IMR BATTERIES ONLY!
  • Please do not put in your battery in wrong direction
  • Make sure battery sit completely snug in the battery slot
  • Do not use any batteries if the outside wrapper has come off!
  • Turn off the device before pulling your battery out
  • Do not wrap your coils below 0.2 ohm and always vape safe!

WHERE: >> HERE <<

USE COUPON CODE JOE10 TO BRING THE TOTAL TO $125.99

Share on FacebookTweet about this on TwitterShare on Google+Share on LinkedInPin on PinterestShare on RedditShare on StumbleUponDigg thisEmail this to someone

Author:

Similar Posts

Comments are closed.